Siemens 6DD1607-0AA2 - Page 143

Configuring
Application Module FM 458-1 DP - User Manual 4-85
A5E01078222-02 Edition 03.2009
The table files must fulfill the following conditions:
 A table file may only comprise two columns – if additional columns are
included in the table, an error message is displayed in a dialog
window.
 Both of the columns must contain the same number of values. If this is
not the case, then the D7-SYS additionalComponentBuilder displays
an error message in a dialog window and the table values are
rejected.
The D7-SYS additionalComponentBuilder expects the following data
format:
 [+/-] xxx.yyy – real value, decimal places are specified using a „.“ (e.g.
145.123)
 [+/-] xxx,yyy – real value, decimal places are specified using a „,“ (e.g.
145,122)
 [+/-] xxx.yyyE+/-mm – real values shown as an exponent, decimal
places are specified using a „.“ (e.g.
145.122E+12)
 [+/-] xxx,yyyE+/-mm – real values shown as an exponent, decimal
places are specified using a „,“ (e.g.
187,122E+12)
For the „Table DINT“ type description:
 [+/-]xxx – Integer or double integer (e.g. 145)
The following conditions still apply for the table files:
 ASCII files
 The table columns are separated using a semicolon or tab character
 Lines are separated using a line break or semicolon
Conditions