Configuring
4-94 Application Module FM 458-1 DP - User Manual
A5E01078222-02 Edition 03.2009
Setting parameters
are configured at block inputs
values can be read, changed and saved in the change memory.
interconnections to other blocks can be changed using BICO
technology
NOTE
You cannot change parameter values if $ signals or virtual connections
are configured at the block inputs.
You can configure the following D7-SYS connection data types of the
blocks as parameter:
D7-SYS connection data type
in CFC
Bool Integer Double
Integer
Word Real SDTime
Parameter data type in the parameter
description
O2 I2 I4 V2 I4 I4
A maximum of 2000 different parameters are available. Each parameter
may only be assigned once. Parameters are configured in CFC as
follows:
Designate the block connection using a pseudo comment @TP_bnnn,
with
b: range identification "H", "L", "c" or "d"
designates the number range
"H" or "L": I/O can only be read and changed
"c" or "d": Connections can only be read
nnn: three-digit parameter number
000 to 999
Connection data
types for
parameters
Configuring
parameters
To Next Page
Loading...
Need help?
General
