Siemens 7SR18 Solkor - Fixings; Crimps; Panel Fixings

7SR18 Installation Guide
Unrestricted ©2018 Siemens Protection Devices Limited Page 9
of
3.2 Fixings
3.2.1 Crimps
Ring crimp terminal with 90˚ bend are recommended.
3.2.2 Panel Fixings
Typical mounting screw kit per Relay consists of the following: -
4 off M4x10 mm Screws
4 off M4 Nuts
4 off M4 Lock Washer
Typical rear terminal block fixing kit (1kit per terminal block fitted to relay) consists of the following: -
28 off M4, 8 mm Screws
28 off M4 Lock Washer
Relay rear retaining screw: -
1 off M3x8 mm Screw