Siemens 7SR18 Solkor - Figure 4.9-1 Sequence Diagram: Quick Logic PU;DO Timers (Counter Reset Mode Off)

7SR18 Description Of Operation
Unrestricted ©2018 Siemens Protection Devices Limited Page 61 of 78
P
.
U
.
D
E
L
A
Y
D
.
O
.
D
E
L
A
Y
Figure 4.9-1 Sequence Diagram: Quick Logic PU/DO Timers (Counter Reset Mode Off)
When the count value = En Counter Target the output of the counter (En) = 1 and this value is held until the
initiating conditions are removed when En is instantaneously reset.
The output of En is assigned in the OUTPUT CONFIG>OUTPUT MATRIX menu where it can be programmed to
any binary output (O), LED (L) or Virtual Input/Output (V) combination.
Protection functions can be used in Quick Logic by mapping them to a Virtual Input / Output.