7SR18 Installation Guide
Unrestricted Page 10 of 24 ©2018 Siemens Protection Devices Limited
Section 4: Rear Terminal Drawings
4.1 E6 Case
Figure 4.1-1 E6 Case viewed from rear (Typical)
Notes
1) Recommended terminations are pre-insulated and must be crimped using approved tooling.
2) RS485 (Block ”B” Terms 14, 16, 18, 20) connection to this communication facility is by screened, twisted
pair cable. On site when wiring other facilities ensure that these terminals are not obscured by other wiring
runs. Cable should be RS485 compliant.
To Next Page
Loading...
