7SR18 Instrumentation Guide
Unrestricted ©2018 Siemens Protection Devices Limited Page 13 of 14
1.15 Binary Output Meters
--------------------
BINARY OUTPUT
> to view
--------------------
This is the sub-group that includes all the meters that are associated with the
Binary Outputs TEST/RESET ► allows access to this sub-group
BO 1-8 ---- ----
Displays the state of DC binary Outputs 1 to 8. (The number of binary
outputs may vary depending on model)
1.16 Virtual Meters
--------------------
> to view
--------------------
This is the sub-group that shows the state of the virtual status inputs in the
relay TEST/RESET ► allows access to this sub-group
V 1-8 ---- ----
Displays the state of Virtual Outputs 1 to 8 (The number of virtual inputs will
vary depending on model)
1.17 Miscellaneous Meters
--------------------
MISCELLANEOUS
> to view
--------------------
This is the sub-group that includes indication such as the relays time and
date, the amount of fault and waveform records stored in the relay
TEST/RESET ► allows access to this sub-group
Start Alarm
Count 00
Target 000
Displays the number of Start Up operations experienced by the relay
Date 01/01/2000
Time 22:41:44
Waveform Recs 0
Fault Recs 0
This meter displays the Date, Time, the number of Waveform Records and
Fault Records stored in the relay.
Event Recs 0
Data Log Recs 0
Settings Group 1
This meter displays the number of Event Records, Data Log Records and
the Active Settings Group number stored in the relay.
1.18 Auto-Reclose Meters
--------------------
> to view
--------------------
This is the sub-group that includes all the meters that are associated with
Autoreclose TEST/RESET ► allows access to this sub-group. Only seen on
models that have the 79 option
Autoreclose Status
Out Of Service
Close Shot 0
Status of the autoreclose.
To Next Page
Loading...
