Siemens 7SR18 Solkor - PRP - Parallel Redundancy Protocol

7SR18 Installation Guide
Unrestricted ©2018 Siemens Protection Devices Limited Page 23
of
6.4.2 PRP – Parallel Redundancy Protocol
The HSR redundancy protocol according to the IEC 62439-3 standard is based on double transmission of
message frames over ring-topology networks in both directions. In the case of an error, the message frame will be
transmitted without any delay. No reconfiguration time is necessary for the network, as is the case for RSTP.
PRP need to be enabled on the device within Reydisp Manager (See Reydisp Manager userguide).
Figure 6.4.2-1 PRP Ethernet Network Configuration