7SR18 Configuration Guide
Unrestricted Page 8 of 12 © 2015 Siemens Protection Devices Limited
Section 3: Configuring the Relay Using Reydisp Evolution
To set the relay using the communication port the user will need the following:-
PC with Reydisp Evolution Installed. (This can be download from our website www.energy.siemens.com and
found under the submenu ‘Software’). This software requires windows 2000-service pack 4 or above, or windows
XP with service pack 2 or above.
3.1 Physical Connection
The relay can be connected to Reydisp Evolution via any of the communication ports on the relay. Suitable
communication Interface cable and converters are required depending which port is being used.
3.1.1 Front USB connection
To connect your pc locally via the front USB port.
Figure 3.1.1-1 USB connection to a PC
To Next Page
Loading...
