7SR18 Instrumentation Guide
Unrestricted Page 14 of 14 ©2018 Siemens Protection Devices Limited
1.19 Communication Meters
--------------------
> to view
--------------------
This is the sub-group that includes all the meters that are
associated with Communications ports TEST/RESET ► allows
access to this sub-group
COM1
COM2
Displays which com ports are currently active
COM1 TRAFFIC
Tx1 0
Rx1 0
Rx1 Errors 0
Displays traffic on Com1
COM2 TRAFFIC
Tx2 0
Rx2 0
Rx2 Errors 0
Displays traffic on Com2
EN100 INFORMATION
Version : EN100 Version Info
Part# BF1111111111
Displays EN100 information
Network Config
Mac 00000000
IP 000.000.000.000
NM 255.255.255.000
Displays EN100 network information
Gateway: 000.000.000.000
EN100 NTP info:
EN100 Link ½ status info:
EN100 Rx/Tx Count
Displays further EN100 61850 information
En100 Rx/Tx Error
En100 Rx/Tx 10s
CPU Load %
EN100 Info Meters : 1-n
Displays further EN100 61850 information
1.20 Quick Logic Meters
--------------------
> to view
--------------------
This is the sub-group that includes all the meters that are associated with
QuickLogic. TEST/RESET ► allows access to this sub-group
E 1-4 ----
Shows the state of all the equations
E1 Equation
EQN =0
TMR 0-0 =0
CNT 0-1 =0
Shows the state of an individual equation. EQN shows the equation state.
TMR shows the timer progress and state for the equation. CNT shows the
count progress and state for the equation.
…
E4 Equation
EQN =0
TMR 0-0 =0
CNT 0-1 =0
Shows the state of an individual equation. EQN shows the equation state.
TMR shows the timer progress and state for the equation. CNT shows the
count progress and state for the equation.
To Next Page
Loading...
