Centrifuge Module Interface Operating Instructions Introduction
092D0001-02 Rev. A page 25
○
Time the last maintenance was performed.
• Maintenance Performed Use this button after performing
maintenance to reset the the following counters:
○ Number of spin cycles completed since the last maintenance was
performed.
○ Time the last maintenance was performed.
Log Area
The Log area allows you to select what is displayed in the Log window. You
may select one or both types of events to display:
• Interface Messages When selected, the Log window displays
messages specific to the automation system interface.
• Centrifuge Activities When selected, the Log window displays
messages specific to the Centrifuge module.
Note No matter which type of message you select, the system logs
messages of both types. Your selection only determines what is displayed
in the Log area.
This area also allows you to save log files in an XML format and clear the
Log window of all messages.
• Save XML When selected, this button allows you to save the log to an
XML format and to start a new log.
• Clear Log When selected, clears the messages from the display.
To Next Page
Loading...
