7SR210 & 7SR220 Configuration Guide
Unrestricted Page 4 of 14 © 2018 Siemens Protection Devices Limited
Section 1: Introduction
1.1 Relay Menus And Display
All relay fascias contain the same access keys although the fascias may differ in appearance from model to
model. The basic menu structure is also the same in all products and consists of four main menus, these being,
Settings Mode - allows the user to view and (if allowed via the settings mode password) change settings in the
relay.
Instruments Mode - allows the user to view the relay meters e.g. current, voltage etc.
Fault Data Mode - allows the user to view the type and data of any fault that the relay has detected.
Control Mode - allows the user to control external plant under the relays control for example the CB (if allowed
via the control mode password)
Event Data Mode - allows the user to view the events which have occured within the relay.
The menus can be viewed via the LCD by pressing the access keys as below,
Figure 1.1-1 Menu Navigation
Pressing CANCEL returns to the Identifier screen
LCD Contrast
To change the contrast on the LCD insert a flat nosed screwdriver into the screwhead below the contrast symbol,
turning the screwhead left or right decreases and increases the contrast of the LCD.
Figure 1.1-2 Fascia Contrast symbol
To Next Page
Loading...
