To Next Page
T
Timothy RobertsSep 1, 2025
What does 'Unconfig' mean on my Siemens FC901-U3?
- LlesliebradleySep 1, 2025
If your Siemens Control Panel displays 'Unconfig', it indicates that the system has found a SLC device that is not in the config file.
What does 'Unconfig' mean on my Siemens FC901-U3?
If your Siemens Control Panel displays 'Unconfig', it indicates that the system has found a SLC device that is not in the config file.
What does 'OverCurrent' mean on my Siemens Control Panel?
If your Siemens Control Panel indicates an overcurrent state, it means the NAC is in an overcurrent state.
What does 'Open' mean on my Siemens FC901-U3?
If your Siemens Control Panel displays 'Open', it indicates that the device is in open trouble.
What does it mean when my Siemens Control Panel displays 'VoltageHigh'?
If your Siemens Control Panel displays a high voltage warning, it indicates that the battery voltage is too high.
What does it mean when my Siemens FC901-U3 Control Panel displays 'VoltageLow'?
If your Siemens Control Panel indicates a low voltage, it means the battery voltage is too low.
What does it mean if my Siemens Control Panel indicates a ground fault?
If your Siemens Control Panel shows a ground fault, it indicates the device is in a ground fault condition.
What does it mean if my Siemens FC901-U3 says 'Short'?
If your Siemens Control Panel indicates a short, it means the device is experiencing a short trouble.
General| Series | FC900 |
|---|---|
| Protection Class | IP30 |
| Type | Fire Alarm Control Panel |
| Operating Temperature | 0°C to 50°C |
| Supply Voltage | 230 VAC |
| Quiescent Current | 150 mA |
| Alarm Current | 500 mA |
| Enclosure rating | Metal |
| Communication interfaces | Ethernet, RS-485 |
| Certifications | EN 54-2, EN 54-4 |
