Siemens Hicom 100 E User Manual

Power supply
Installation
A31003-K16-X001-3-7620
,
07/99
5-4
Hicom 100 E Version 2.1, Service manual
5.3.4 Battery for UPS2
●
1 battery box for wall mounting with rechargeable battery and connecting cable (0.4 m) to
the power supply unit
●
4 wall plugs, 4 woodscrews
●
Bridging times, see Table 3-27
5.3.5 Installing the battery box
If the UPS (uninterruptible power supply) is required, proceed as follows:
●
Mount the battery box on the wall, no more than 40 cm from the power supply unit
●
Connect the cable to the PSU. Check the switch setting!
On = mains/battery operation
Off = mains operation
Figure 5-3 Connecting the UPS battery cable
Danger
Do not insert the power cable in the mains socket until all installation and connection
work has been completed.
Connecting socket
for battery (UPS only)
Switch (UPS only) for
mains/battery operation = on
Mains operation = off
To system unit
Pull power supply before
installing system
expansions
Power cable (rubber connector)
Battery fuse (UPS)
Mains fuse
OFF
ON
UPS
!

Siemens Hicom 100 E Specifications

General

Brand	Siemens
Model	Hicom 100 E
Category	Telephone
Language	English