Step by Step
Making call
20
Voice Dialling
Dial numbers by just saying a name.
Precondition: ENB entries must have added VoiceDial,
see Æ Page 28.
Using voice dialling
n Lift handset.
or
Press key.
b + m Press the voice dial key combination on the
optiPoint application module.
The display changes to Voice Recognition mode.
s Say the name of the person you want to call.
w The name associated with the corresponding telephone
number is announced. The number is dialled. The
display changes to the start page.
Voice dial unsuccessful
If the name spoken was not recognized by the system
(e.g. spoken with a different intonation or more softly
than in the recording), a message will appear in the
display telling you to try again.
Click on the softkey in the application bar to start a new
voice dial.
s Repeat the name of the person you wish to call.
w The name associated with the corresponding telephone
number is announced. The number is dialled. The
display changes to the start page.
Observe the instructions shown in the display
while dialling.
Speaker
Try again
To Next Page
Loading...
Need help?
General