Siemens Hipath 5000 - Functions You Can Use

Step by Step
Setting Up the Telephone
18
Only if no DHCP server:
Press function key 1.
ddd Enter the code to switch the DHCP IP assign off.
r Complete entry.
Press function key 1.
de Enter the code.
o Enter the IP address of the optiPoint 410 entry
(to edit see  Page 106).
r Complete entry.
Press function key 1.
df Enter the code.
o Enter the terminal mask of the optiPoint 410 entry
(to edit see  Page 106).
r Complete entry.
Press function key 1.
dg Enter the code.
o Enter the default route of the optiPoint 410 entry
(to edit see  Page 106).
r Complete entry.
Only if you are working in a Virtual LAN (VLAN):
Press function key 1.
fid Enter the code to set VLAN Discovery Mode to manual
configuration
.
r Complete entry.
Press function key 1.
fh Enter the code.
o Enter (0 - 4095) for the Virtual LAN ID  Page 73
(to edit see  Page 106).
r Complete entry.