Step by Step
Administration
36
Restarting the Telephone
Web-Based Management tool
Reset via the web-based management tool  Page 51.
1. Open the dialog "Restart Terminal".
Menu: Administrator Actions > Restart Terminal
2. Click the "Restart" button.
Interrupting the Power Supply
Disconnect the red Western plug of the power supply
unit cable (Pos.
3  Page 13) or, for "Power over LAN",
disconnect the LAN cable (Pos. 1  Page 13) from the
optiPoint 410/420 for a few seconds.
Then reconnect the plug.
After Restart
The following messages appear in sequence following
a normal restart:
Idle display after successful restart.
Warning: Restarting
User request
NETBOOT - 1.10
optiPoint 410
4:28PM 16.07.03
1228 >
To Next Page
Loading...
