Alphabetical Reference
89
SNMP Server Address
•If an  SNMP server exists in the network, enter the  IP Address of
this server here.
• Default address  Page 109.
 Page 63
SNMP Trap Port
• Define the  Port here through which the  SNMP error messages
should be transmitted.
 Page 63
SRSR Automatic Switch Back
• Activate this checkbox for executing an automatic switch between
standby mode (emergency mode) and home mode (standard mode) of
the communication platform.
 Page 67
SRSR Enabled
• Activate this checkbox if two communication platforms are used (Main
 PBX and Standby  PBX).
• The  Gateway Address and  Subscriber Number of the Standby
 PBX must be entered  Page 65.
 Page 67
SRSR Switch To Home Expiry Timeout
• Required waiting time for changing from standby mode (emergency
mode) to home mode (standard mode). During this time a switch over
is not possible.
• Valid values: 1 ... 255.
• Default value  Page 109.
 Page 67
SRSR Switch To Home Retry Count
• Maximum number of negative attempts for switching over from home
mode (standard mode) to standby mode (emergency mode).
• Valid values: 1 ... 255.
• Default value  Page 109.
 Page 67
SRSR Switch To Standby Expiry Timeout
• Required waiting time for changing from home mode (standard mode)
to standby mode (emergency mode). During this time a switch over is
not possible.
• Valid values: 1 ... 255.
• Default value  Page 109.
 Page 67
To Next Page
Loading...
