No. Screen
form param‐
eter
Cycle pa‐
rameter
Meaning
13 DZ S_ID Absolute incremental value
1. Incremental infeed of the 3rd axis of the plane (Z for G17)
Infeed direction via sign of S_ID. For measurement of spigot, rib and rectangle out‐
side, S_ID is used to define the lowering to measuring height.
2. Consideration of a protection zone
For measurement of hole, groove and rectangle inside and a protection zone, S_ID is
used to define the overtravel height.
14 X1 S_SZA Diameter or length (width) of the protection zone
7)
15 Y1 S_SZO For "Measure rectangle": Width of the protection zone of the 2nd axis of the plane
16 X S_MA Number of the measuring axis
7)
(only for measurement of groove or rib)
Val‐
ues:
1 = 1st axis of the plane (for G17 X)
2 = 2nd axis of the plane (for G17 Y)
17 ST _DP Number of the replacement tool (duplo number) to be corrected
18 Measure‐
ments
S_NMSP Number of measurements at the same location
2)
(value range 1 to 9)
19 TR S_TNAME Tool name
2)
20 DL S_DLNUM Setup additive offset DL number
5)
21 TZL S_TZL Work offset
2), 4)
22 DIF S_TDIF Dimensional difference check
2), 4)
23 TUL S_TUL Upper tolerance limit (incremental to the setpoint)
4)
24 TLL S_TLL Lower tolerance limit (incremental to the setpoint)
4)
25 TMV S_TMV Offset range for averaging
2)
26 FW S_K Weighting factor for averaging
2)
27 S_EVNUM Data set, empirical mean value memory
2), 8)
28 S_MCBIT Reserved
29 _DMODE Display mode
Val‐
ues:
UNITS: Machining plane G17/G18/G19
0 = Compatibility, the plane active before the cycle call remains active
1 = G17 (only active in the cycle)
2 = G18 (only active in the cycle)
3 = G19 (only active in the cycle)
30 _AMODE Alternative mode
Val‐
ues:
UNITS: Dimensional tolerance yes/no
0 = No
1 = Yes
1)
All default values = 0 or marked as the range of values a to b
2)
Display depends on the general SD54760 $SNS_MEA_FUNCTION_MASK_PIECE
3)
Only for offset in tool, otherwise parameter = ""
4)
Only for offset in tool and dimensional tolerance "Yes", otherwise parameter = 0
5)
Only if the "Setup additive offset" function has been set-up in the general MD 18108 $MN_MM_NUM_SUMCORR . In
addition, in the general MD 18080 $MN_MM_TOOL_MANAGEMENT_MASK , bit8 must be set to 1.
6)
If WO "fine" has not been set up in MDs, correction is according to WO "coarse"
Work preparation
3.25 Programming cycles externally
NC programming
1174 Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
To Next Page
Loading...
Need help?
General
