Siemens MCP 398C Programming Manual

Program code Comment
N2000 R10=R20+100
N2010 ...
N2200 RET("subProg2") ; Return jump into the main program at block
N1400
Subprogram subProg2:
Program code Comment
PROC subProg2
N2000 R10=R20+100
N2010 ...
N2200 RET("iVar1") ; Return jump into the main program at block
N1500
Subprogram subProg3:
Program code Comment
PROC subProg3
N2000 R10=R20+100
N2010 ...
N2200 RET("subProg1") ; Return jump into the main program at block
N1550
Additional information
The following diagrams show the different effects of return jump parameters
Work preparation
3.2 Subprogram technique
NC programming
516 Programming Manual, 12/2019, 6FC5398-2EP40-0BA0

Siemens MCP 398C Specifications

General

Brand	Siemens
Model	MCP 398C
Category	Control Systems
Language	English