Siemens MXL-IQ - MXL-IQ Walktest Operating Instructions

A Walktest of the MXL-IQ System enables
a qualified technician to test the operation
of input points on the MXL-IQ with or
without disabling the entire fire alarm
system. Testing can be either silent or with
audible feedback in the following ways:
1. Entire system
2. ALD loop (60 subaddresses)
3. CZM-4 module (4 zones)
4. Conventional zone (individual
CZM-1B6 or CZM-4 zone)
5. MOI-7 (MID-16) inputs (128
subaddresses)
If a printer is installed, a printed record of
the test is made.
The Walktest is available with MXL-IQ
Operating Software. You must enter your
1-5 digit password before you can use the
Walktest functions. Enter the Walktest
through the MXL-IQ Main Menu (See
Chapter 3, Operating Instructions).
The MXL-IQ Main Menu structure with
Walktest included is:
MXL-IQ Main Menu
ACKNOWLEDGE
LIST
CONTROL
TEST
WALKTEST
The table below shows the selections in the Walktest Menu and
their related help messages.
Chapter
5
Walktest Operating
Instructions
INTRODUCTION
02ELBAT
uneMtsetklaW
TSETKLAWEGASSEMPLEH
DUAwmetsySsDUAhtiwmetsySlluFtseT
DUAwpooLsDUAweludoM4-MZC/)puorg61-DIM(7-IOM/pooLDLAtseT
DUAwenoZsDUAhtiwe
noZ6B1-MZC/4-MZCtseT
LISmetySmetsySlluFtseTtneliS
LISpooLsDUAweludoM4-MZC/)puorg61-DIM(7-IOM/pooLDLAtseTt
neliS
LISenoZenoZ6B1-MZC/4-MZCtseTtneliS
lecnaCssergorpnitsetklaWlecnaC
dnetxEtfelsruoh4otremittsetteseR
5-1