3-35
Operation
LIST: PERCENT/FT
Press ENTER to select List Percent/ft. The
System asks you for a module and device
number.
TYPE IN MODULE & DEVICE: 001-001
Type in the three-digit module number and
the three-digit device number using the
numeric keypad and press ENTER. The
System displays the following menu for that
device (the S in Senstvty will be blinking):
002-003 SENSTVTY PRE-ALARM ANALOG
List Percent/ft – Senstvty
The display for Sensitivity supplies the
current sensitivity as read back from the
detector and is similar to the following
(readings are dynamic):
002-003 SENS 1.4%/FT NORM
List Percent/ft – Pre-alarm
The display for Pre-alarm supplies the
current Pre-alarm setting read back from
the detector and is similar to the following
(readings are dynamic):
002-003 PRE-ALARM 1.4%/FT NORM
List Percent/ft – Analog
The display for Analog supplies the current
analog2 reading read from the detector and
is similar to the following (readings are
dynamic):
002-003 SENS 1.4%/FT NORM
To leave the Percent/ft menu without going
through all subaddresses, press the Up
arrow key. The System displays the List
menu.
Print the Analog Loop’s Current Readings in
Percent/ft Obscuration
Press PRINT when the P in Percent/ft is
blinking. The System asks you for a module
number.
TYPE IN MODULE NUMBER:
Type the three-digit module number using
the numeric keypad and press ENTER. The
System shows the following menu for that
device (the S in Senstvty will be blinking):
001-001 SENSTVTY PRE-ALARM ANALOG
The System prints either the Sensitivity, Pre-
alarm, or Analog of all the devices for the
specified module in a format similar to the
following (NA = ID-60 detector):
%/ft SENSITIVITIES FOR MODULE 2
1-3.00 2-NA 3-1.4 4-3.1 5-1.4
6-1.4 7-ND 8-ND 9-ND 10-ND
11-ND 12-ND 13-ND 14-ND 15-ND
16-ND 17-ND 18-ND 19-ND 20-ND
21-ND 22-ND 23-ND 24-ND 25-ND
26-ND 27-ND 28-ND 29-ND 30-ND
31-ND 32-ND 33-ND 34-ND 35-ND
36-ND 37-ND 38-ND 39-ND 40-ND
41-ND 42-ND 43-ND 44-ND 45-ND
46-ND 47-ND 48-ND 49-ND 50-ND
51-ND 52-ND 53-ND 54-ND 55-ND
56-ND 57-ND 58-ND 59-ND 60-ND
List: ASD_apps
Use List ASD_apps to display operational
characteristics of the ASD devices.
From the List menu use the left or right
arrow key to cause the A in ASD_Apps to
start blinking:
LIST: ASD APPS
Display the Operational Characteristics of One
Device
Press ENTER to select ASD_apps. The
System asks you for a module and device
number:
TYPE IN MODULE & DEVICE:
To Next Page
Loading...
