3-24
Operation
When the System has shown all current fire
alarms, it returns to the List menu.
To obtain a full printed list of alarms in
the following format—one item for each
current alarm—press PRINT when the A in
ALARM is blinking.
Listing of all Alarm at 14:35:20 Oct 09,20XX:
ALARM 1-5 14:34:22 Oct 09,20XX #1
[custom message], [device type]
In the above listing, 1-5 is the address of
the device in alarm, the time is the time the
device went into alarm, #1 is the number of
this alarm in the current list, [custom
message] is the custom message for the
device in alarm, and [device type] is the
type of device in alarm.
(To end a menu session and return to the
Main Menu or to leave the menu at any time,
press the Up arrow key to go backward one
menu each time.)
List: Supervisory
The List Supervisory function shows you all
the supervisories currently in the System in
the order they occurred.
From the List menu, use the Left or Right
arrow key to cause the S in SUPERVSRY
to blink.
(If you press HELP at this point, the System
explains the List Supervisory function:
SHOW INDIVIDUAL SUPERVISORY
Press HELP again to return to the List
menu.)
Press ENTER to select SUPERVSRY and
display supervisory information on the
MKB-4 display.
If There Is No Supervisory:
If there is no supervisory, the System briefly
displays the following message and then
returns you to the List menu:
NO SUPERVISORY EXISTS
If There Is a Supervisory:
If there is at least one supervisory, the
System shows the most recent supervisory,
alternating between the following two
displays:
1-001
[custom message]
002
[device type]
IN SUP
1-001
[custom-message]
002
[time/date]
IN SUP
Press NEXT to show the two displays for the
previous supervisory in the sequence.
(Pressing HOLD freezes a display for as
long as you keep HOLD depressed.)
When the System has shown all current
supervisories, it returns to the List menu.
To obtain a full printed list of
supervisories in the following format—one
item for each current supervisory—press
PRINT when the S in SUPERVISORY is
blinking.
Listing of all Supervsry at 14:35:20 Oct 09,20XX:
SUPERV IN 32-45 14:34:22 Oct 09, 20XX
#7
[custom message], [device type]
In the preceding listing, 32-45 is the ad-
dress of the device in supervisory, #7 is the
number of the supervisory in the current list,
[custom message] is the custom message
for the device in supervisory, and [device
type] is the type of device in supervisory.
(To end a menu session and return to the
Main Menu or to leave the menu at any time,
press the Up arrow key to go backward one
menu each time.)
List Security Conditions
The List Security function shows you all the
security conditions currently in the System in
the order they occurred.
From the List menu, use the left or right
arrow key to cause the S in SECURITY to
blink.
(If you press HELP at this point, the System
explains the List Security function:
SHOW INDIVIDUAL SECURITY STATUS
Press HELP again to return to the List
menu.)
To Next Page
Loading...
