Siemens NXAIR - Page 136

Operating the contactor panel with panel width 435 mm
136 NXAIR / ≤ 40 kA 110-0134.9 / 14
Positioning the contactor truck in front of the panel
INFORMATION
Plugging on the low-voltage connector
The low-voltage connection couples automatically when the contactor truck is
inserted.
Move the contactor truck centrally in front of the contactor panel. The front wheels (1) of the
contactor truck point towards the ramps (2) at the bottom of the panel.
Fig. 238: Positioning the contactor truck in front of the panel
If required, support the contactor truck with the handle (3) to move it onto the ramps.
1
2