Siemens RX1400 - Page 25

RUGGEDCOM NETCONF
Reference Guide
Chapter 1
Introduction
Sample Session: Editing Data 13
<?xml version="1.0" encoding="UTF-8"?>
<rpc-reply xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="1016">
<ok/>
</rpc-reply>]]>]]>
The changes made to the <candidate> configuration are committed and promoted to the <running>
configuration.
9. Issue an <rpc> request to unlock the candidate configuration:
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="1017">
<unlock>
<target>
<candidate/>
</target>
</unlock>
</rpc>]]>]]>
The device responds with the following:
<?xml version="1.0" encoding="UTF-8"?>
<rpc-reply xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="1017">
<ok/>
</rpc-reply>]]>]]>
10. Issue an <rpc> request to unlock the running configuration:
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="1018">
<unlock>
<target>
<running/>
</target>
</unlock>
</rpc>]]>]]>
The device responds with the following:
<?xml version="1.0" encoding="UTF-8"?>
<rpc-reply xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="1018">
<ok/>
</rpc-reply>]]>]]>
11. Close the session:
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="1019" >
<close-session/>
</rpc>]]>]]>
The device responds with the following and closes the session:
<?xml version="1.0" encoding="UTF-8"?>
<rpc-reply xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="1019">
<ok/>
</rpc-reply>]]>]]