Mounting
3.1 Mounting on the switching panel
PAC3120 and PAC3220
Equipment Manual, 10/2019, L1V30425208F-01
37
3.1 Mounting on the switching panel
You will require the following tools to install the device:
● Cutting tool for the panel cutout
● PH2 cal. screwdriver acc. to ISO 6789
Additional installation tools
● Cable clamp for strain relief of the communication cable and the connecting cables at the
digital inputs/outputs.
Mounting and clearance dimensions
You can find information on the cutout dimensions, frame dimensions and clearances in
chapter Dimensional drawings (Page 109).
Installation steps
Proceed as follows to install the power monitoring device in the switching panel:
Figure 3-2 Mounting
To Next Page
Loading...
