Address Min/Max Value Parameters Unit Type
27 – Overcurrent alarm time (milliseconds) ms uInt16
28 – Overcurrent alarm time (hours and minutes) h and min uInt16
29 – Overcurrent alarm time (month and date) month and date uInt16
30 – Overcurrent alarm time (year) year uInt16
31 – Overcurrent warning type – uInt16
32 – Overcurrent warning time (milliseconds) ms uInt16
33 – Overcurrent warning time (hours and
minutes)
h and min uInt16
34 – Overcurrent warning time (month and date) month and date uInt16
35 – Overcurrent warning time (year) year uInt16
For more information about register-type data – events, see B.7 Register-Type Data - Events.
Table B-8 Events
Address Min/Max Value Modbus Data
Type
Parameters Unit Type
299 – – Reserved for future use – –
300 0 to 65535 Inp-Reg Event counter – uInt16
301 to
491
0 to 65535 Inp-Reg Event type – uInt16
302 to
492
0 to 59999 Inp-Reg Time in milliseconds ms uInt16
303 to
493
0 to 23
0 to 59
Inp-Reg Time in hours and
minutes
h and min uInt16
304 to
494
1 to 31
1 to 12
Inp-Reg Time in month and date month and date uInt16
305 to
495
12 to 99 Inp-Reg Time in year year uInt16
306 to
496
0 to 9999 Inp-Reg Phase current I
1
A uInt16
307 to
497
0 to 9999 Inp-Reg Phase current I
2
A uInt16
308 to
498
0 to 9999 Inp-Reg Phase current I
3
A uInt16
309 to
499
0 to 65535 Inp-Reg Ground current I
N
1/100 A uInt16
310 to
500
– Inp-Reg Reserved – uInt16
Read or write accesses to any addresses beyond the defined address range can cause the exception code 02. If
any value written beyond the range of defined value display the exception code 03. The modified values
contained in the registers are saved during a device reset.
For more information about register-type data - trailing pointers, see B.8 Register-Type Data – Trailing
Pointers.
Modbus Registers
B.2 Implementation of the Modbus Protocol
104 SICAM, Feeder Condition Monitor, Manual
E50417-H8940-C580-A4, Edition 03.2019
To Next Page
Loading...
