Siemens SICAM - Page 169

Modbus Register Address Parameter Individual Test Value
494 Time in dd and month 494
495 Time in year 495
496 Phase current I
1
496
497 Phase current I
2
497
498 Phase current I
3
498
499 Ground current I
N
499
500 Reserved 0
i
i
NOTE
The time duration for the following registers are 10 s:
•
Analog Input Register: Measurement and Live Values
•
Overvoltage/Undervoltage/Overcurrent Alarm and Warning
•
Trailing pointers
•
Events
i
i
NOTE
Modbus holding registers are not tested in the self-test mode.
i
i
NOTE
Enable the self test after ensuring that there is no fault condition exists. During the self-test mode duration
if any fault occurs, the fault conditions are not updated in the device.
Modbus Registers
B.9 Self-Test Mode
SICAM, Feeder Condition Monitor, Manual 169
E50417-H8940-C580-A4, Edition 03.2019