Index-3
ET 200L Distributed I/O Device
EWA-4NEB 780600902-05
M
Manual
order number
S5, A-6
S7, A-6
purpose of, iii
Manufacturer ID, B-4
definition, 5-6
structure, 5-6
Master, Glossary-4
Master PROFIBUS address
definition, 5-6
structure, 5-6
Mechanical environmental conditions, 6-7
N
Node, Glossary-4
Non-isolated, Glossary-4
O
ON, 5-2
Operating regulations, 3-2
Optical link module, order number, A-5
Order number, A-1
accessories for PROFIBUS-DP, A-5
bus cable, A-5
bus connector, A-5
direct-buried cable, A-5
drum cable, A-5
electronics block, A-2
labeling strip, A-2
manual
S5, A-6
S7, A-6
optical link module, A-5
PROFIBUS drop cable, A-5
RS 485 repeater, A-5
supplementary terminal, A-2
terminal block, A-2
Overall installation in TN system, 3-6
P
Parameterization, Glossary-5
Power supply, 1-4
Preface, iii
Previous version, of the manual, iii
Product overview, 1-1
PROFIBUS, Glossary-5
address, Glossary-5
location of rotary switch, 2-6
address modifying, 2-6
address validity, 2-6
PROFIBUS address, setting, 2-6
PROFIBUS drop cable, order number, A-5
PROFIBUS-DP terminal connection, 3-12
PROFIBUS-DP, 1-2, Glossary-5
Programmable logic controller, Glossary-5
Protection against electrical phenomena, 3-3
Protective measures, 3-4
PS. See Power supply
Pulse-shaped interference, 6-4
R
Rail, 1-4
Rated voltage, 6-9
Recycling, iii
Reference potential, Glossary-5
Rotary switch, 2-6
RS 485 repeater, order number, A-5
Rules, general, 3-2
S
Safety class, 6-8
Safety regulations, 3-2
Scope of this manual, iii
Service & Support on the Internet, iv
Shipping conditions, 6-6
Sine-shaped interference, 6-5
Slave, 5-3, Glossary-6
diagnosis, structure, 5-4
requesting, 5-4
Standards, 6-2
Standards and certification, 6-2
Start-up, 4-3
of plant, 3-2
Station status
definition, 5-5
structure
Part 1, 5-5
Part 2, 5-6
Part 3, 5-6
STEP 7, 4-1
Storage conditions, 6-6
Structure of the slave diagnosis, 5-4
To Next Page
Loading...
