ET 200PA SMART I/O modules
10
10.1 Module overview
The following I/O modules are available in the ET 200PA SMART system:
Module Article no. Article no. (with conformal
coating)
Digital input module DI16xDC24V 6ES7650-8DK70-0AA0 6ES7650-8DK70-1AA0
Digital input module DI32xDC24V 6ES7650-8DK80-0AA0 6ES7650-8DK80-1AA0
Digital output module DO16xDC24V/0.5A 6ES7650-8EK70-0AA0 6ES7650-8EK70-1AA0
Digital output module DO32xDC24V/0.5A 6ES7650-8EK80-0AA0 6ES7650-8EK80-1AA0
Analog input module AI8x13Bit 6ES7650-8AE60-0AA0 6ES7650-8AE60-1AA0
Analog input module AI8x16Bit 6ES7650-8AK60-0AA0 6ES7650-8AK60-1AA0
Analog input module AI16x16Bit 6ES7650-8AK70-0AA0 6ES7650-8AK70-1AA0
Analog input module AI8xTC/4xRTD 6ES7650-8AR60-0AA0 6ES7650-8AR60-1AA0
Analog output module AO8x12Bit 6ES7650-8BK60-0AA0 6ES7650-8BK60-1AA0
In addition to the ET 200PA SMART I/O modules specified in this table, the following modules
can also be used in an ET 200PA SMART system.
● Numerous S7-300 standard I/O modules and HART analog modules that are also approved
for use in an ET 200PA SMART in the list of released modules PCS 7 (as of V8.1).
● Numerous counter modules and point-to-point couplings which are also approved for use in
an ET 200PA SMART in the list of released modules PCS 7 (as of V8.1).
If you are using modules from the S7-300 series of modules, you can find information for them
in the following manuals:
● Automation System S7-300, Module Data (http://support.automation.siemens.com/WW/
view/en/8859629)
● ET 200M, Signal Modules for Process Automation (http://
support.automation.siemens.com/WW/view/en/7215812)
● ET 200M Distributed I/O Device HART Analog Modules (http://
support.automation.siemens.com/WW/view/en/22063748)
Note
The ET 200PA SMART I/O modules function only in an ET 200PA SMART station conjunction
with an IM 650 interface module.
If the ET 200PA SMART modules are located behind an ET 200M interface module or an
S7-300 CPU, the function of the ET 200PA SMART modules is not available. The ET 200PA
SMART modules indicate this by a red SF LED (group error LED) flashing at 2 Hz.
The ET 200PA SMART modules do not affect the ET 200M / S7-300 bus. This means other
modules of the ET 200M / S7 300 station remain operable without restriction.
ET 200PA SMART
Operating Instructions, 06/2019, A5E34192013-AB 123
To Next Page
Loading...
Need help?
General
