Connecting
4
4.1 Overview
Introduction
For the configuration of an ET 200PA SMART, you must also take into account the mechanical
and electrical configuration. Information on this be found in section "Assignment planning
(Page 17)".
Basic rules
In view of the many and varied applications of an ET 200PA SMART, this section can only
describe the basic rules for the electrical configuration. You must observe these basic rules at
a minimum in order to ensure trouble-free operation of the ET 200PA SMART.
4.2 Connecting PROFIBUS DP
4.2.1 Connecting the Bus Connector
Applicable bus connectors
To connect to the PROFIBUS DP it is preferable to use the following FastConnect bus
connectors:
● Up to 12 MBaud, with vertical cable outlet
– without PG socket (6ES7972‑0BA50‑0XA0)
– with PG socket (6ES7972‑0BB50‑0XA0)
● Up to 12 MBaud, with diagonal cable outlet
– without PG socket (6ES7972‑0BA60‑0XA0)
– with PG socket (6ES7972‑0BB60‑0XA0)
These guarantee a fast and reliable wiring with FC bus cable
ET 200PA SMART
Operating Instructions, 06/2019, A5E34192013-AB 41
To Next Page
Loading...
