Validity of the information on the components
NOTICE
Markings and approvals
In the documentation, you can find the markings and approvals which are generally possible
or planned in the system.
The identification or approval that is printed on the module continues to be exclusively valid.
The currently valid markings and approvals are printed on the component.
ATEX approval
Table 10-22 ATEX certification
Type Examination Certificate Number DEKRA 19ATEX0043X
Standards EN 60079‑0
EN 60079‑7
ATEX II 3 G Ex ec IIC T4 Gc
Special conditions:
Note
Special conditions
1. The device may only be used in areas with a pollution degree of not more than 2 according
to EN 60664‑1.
2. The modules must be installed in a suitable enclosure which provides a degree of protection
of at least IP54 in accordance with EN 60079‑7, taking into account the ambient conditions
of use.
3. Measures must be taken to protect against exceeding the rated operating voltage by
transient interference voltages of more than 119 V.
IECEx - approval
Table 10-23 IECEx certification
Certificate number DEK 19.0023X issue 0
Standards IEC 60079-0
IEC 60079-7
IECEx Ex ec IIC T4 Gc
ET 200PA SMART I/O modules
10.9 Approvals for the analog input module 6ES7650-8AE60-xAA0
ET 200PA SMART
218 Operating Instructions, 06/2019, A5E34192013-AB
To Next Page
Loading...
Need help?
General
