Siemens SIMATIC ET 200PA SMART User Manual

Structure of the identifier-related diagnostics
The identifier-related diagnostics for ET 200PA SMART is structured as follows:






%\WH
%\WH
%\WH
%LWQR
/HQJWKRIWKHLGHQWLILHUUHODWHGGLDJQRVWLFV
LQFOXGLQJE\WH E\WHV
&RGHIRULGHQWLILHUUHODWHGGLDJQRVWLFV
(QWU\IRU,0b
(QWU\IRUPRGXOHLQVORW
(QWU\IRUPRGXOHLQVORW
(QWU\IRUPRGXOHLQVORW
(QWU\IRUPRGXOHLQVORW
(QWU\IRUPRGXOHLQVORW
%LWQR
%LWQR
(QWU\IRUPRGXOHLQVORW
(QWU\IRUPRGXOHLQVORW
(QWU\IRUPRGXOHLQVORW
(QWU\IRUPRGXOHLQVORW
(QWU\IRUPRGXOHLQVORW
(QWU\IRUPRGXOHLQVORW
Figure 8-3 Structure of the identifier-related diagnostics
The entry for a module at slot x is set if:
● The module is pulled
● A non-configured module is plugged
● An inserted module cannot be accessed
● The modules signals a diagnostic interrupt
● The ET 200PA SMART is not configured with active bus elements although "Module
replacement in runtime" is enabled in the configuration. In this case, the IM 650 sets the bit
for all modules of the station.
Interrupt, error and system messages
8.3 S7 diagnostics
ET 200PA SMART
Operating Instructions, 06/2019, A5E34192013-AB 97

Siemens SIMATIC ET 200PA SMART Specifications

General

Brand	Siemens
Model	SIMATIC ET 200PA SMART
Category	Control Systems
Language	English