Siemens SIMATIC ET 200SP CM 1xDALI - Page 30

Programming
5.3 System function blocks
ET 200SP Communication module CM 1xDALI (6ES7137-6CA00-0BU0)
Manual, 06/2019, A5E46959434-AA
29
Bit
Explanation of status
Bit 8
Several error frames on the bus.
Bit 9 to Bit 31 Reserved
3
When the module is disabled by other DALI application controllers, the CM 1xDALI cannot send out any
forward frame (16-bits or 24-bits) to the bus, but it can send out the response frame (8-bits) to other DALI
application controllers.
4
When the module is disabled by the module parameters, the CM 1xDALI cannot send out any forward
frame or response frame to the bus.
5
When the input voltage 24 VDC is lower than 16V±1V, the PWR LED changes from green to off.
Parameter EVENT_INFO
EVENT_INFO of push button (instance type 1)
Event information
Event name
Description
2#00_0000_0000
Button released
The button is released.
2#00_0000_0001
Button pressed
The button is pressed.
2#00_0000_0010
Short press
6
Press the button and release quickly.
2#00_0000_0101
Double press
Press the button twice in rapid succession.
2#00_0000_1001
Long press start
6
Press the button and hold for longer than the T
short
.
2#00_0000_1011 Long press repeat
6
The button is still pressed after a long press. The event occurs at
regular intervals as long as the condition holds.
2#00_0000_1100
Long press stop
6
The button is released after a long press.
2#00_0000_1110 Button free The button is restored from getting stuck.
2#00_0000_1111
Button stuck
The button is pressed for a very long time and is assumed stuck.
Others Reserved
6
To configure instance related parameters for push button, refer to
DALI_SENSOR_SET_INST_PARAM (Page 97).
EVENT_INFO of absolute input devices (instance type 2)
Event information
Event name
description
positionEvent Position report A position report contains the actual position of the sensor. Refer
to the DALI Device Manual from the manufacturer for details.
EVENT_INFO of occupancy sensor (instance type 3)
Event information
Event name
description
2#00_0000_***0
No movement
Does not detect movement.
2#00_0000_***1
Movement
Detects movement.
2#00_0000_*00*
Vacant
The area is vacant.
2#00_0000_*10* Still vacant The area is still vacant. The event occurs at regular intervals as
long as the vacant condition holds.