Siemens SIMATIC Ident - Page 16

Setting parameters for blocks
3.1 Overview of the Ident library
Ident profile and Ident blocks, standard function for Ident systems
16 Function Manual, 10/2018, C79000-G8976-C387-04
Ident device
Supported blocks/commands
RF18xC
Ident blocks
• Config_Download
• Config_Upload
• Set_Param
• AdvancedCMD
Depending on the connected end device, the blocks/commands
of the respective devices are supported by the reader interface
(the module):
• General reader
Ident profile
• READER-STATUS
• READ-CONFIG
• WRITE-CONFIG
Depending on the connected end device, the blocks/commands
of the respective devices are supported by the reader interface
(the module):
• General reader
RF600 (RF61xR/RF68xR)
Ident blocks
• Config_Download
• Config_Upload
• Set_Param
• AdvancedCMD
Ident profile
• PHYSICAL-READ
• PHYSICAL-WRITE
• READER-STATUS
• INVENTORY
• WRITE_ID
• KILL-TAG
• LOCK-TAG-BANK
• EDIT-BLACKLIST
• GET-BLACKLIST
• READ-CONFIG
• WRITE-CONFIG
MV400/MV500
Ident blocks
• Set_MV_Program
• AdvancedCMD
• Reset_MV
• Read_MV
Ident profile
• PHYSICAL-READ
• PHYSICAL-WRITE
• WRITE-CONFIG