Siemens SIMATIC Ident - Page 15

Setting parameters for blocks
3.1 Overview of the Ident library
Ident profile and Ident blocks, standard function for Ident systems
Function Manual, 10/2018, C79000-G8976-C387-04
15
Position
Block name
Description
IID_INVENT_
00_MOBY_U
Data types for the result of "Inventory" with the
relevant attribute.
The data types help you to interpret the data
received from the reader and to process the
data further directly without data type conver-
sions.
IID_INVENT_
82_83_RF600
IID_INVENT_
85_RF600
IID_INVENT_
8x_9x_RF6_D
IID_INVENT_
A0_A1_RF600
Note
Parallel operation using Ident blocks and Ident profile is not possible
Note that the reader cannot be operated at the same time using the Ident blocks and the
Ident profile.
Blocks/commands supported by Ident devices
The following table provides an overview of the blocks and commands supported by the
Ident devices.
Table 3- 2 Supported blocks/commands
Ident device
Supported blocks/commands
ASM 456
Ident blocks
Depending on the connected end device, the blocks/commands
of the respective devices are supported:
• RF600
• General reader
Ident profile
RF170C/RF180C
Ident blocks
Depending on the connected end device, the blocks/commands
of the respective devices are supported:
• General reader
Ident profile