Setting parameters for blocks
3.1 Overview of the Ident library
Ident profile and Ident blocks, standard function for Ident systems
14 Function Manual, 10/2018, C79000-G8976-C387-04
Ident_Profile These blocks are available for experts to be
able to include complex command structures
in their own program sequence. It is also pos-
sible to use repeat commands and chaining.
Using the status blocks you obtain information
on the reader or transponder.
Using these blocks, it is simple to program
communication with the Ident systems.
The reset blocks are used for simple initializa-
tion of the Ident systems if the "Re-
set_Reader" block is not supported by the
Ident system.
PLC data types System data types IID_HW_CONNECT Data type for all blocks for physical addressing
of communications modules and readers and
for synchronizing the function blocks used for
IID_CMD_STRUCT Data type for the Ident profile for setting the
Status data types IID_READSTAT_
Data types for the result of "Reader_status"
with the relevant attribute.
The data types help you to interpret the data
received from the reader and to process the
data further directly without data type conver-
sions.
IID_READSTAT_
IID_READSTAT_
86_RF300
IID_READSTAT_
Data types for the result of "Tag_status" with
the relevant attribute.
The data types help you to interpret the data
received from the reader and to process the
data further directly without data type conver-
sions.
IID_TAG_STATUS_
To Next Page
Loading...
Need help?
General