Siemens SIMATIC Ident - Page 38

Setting parameters for blocks
3.4 Programming Ident blocks
Ident profile and Ident blocks, standard function for Ident systems
38 Function Manual, 10/2018, C79000-G8976-C387-04
Name
Type
Comment
EPC[5]
BYTE
EPC[6]
BYTE
EPC[7]
BYTE
EPC[8]
BYTE
EPC[9]
BYTE
EPC[10]
BYTE
EPC[11]
BYTE
EPC[12]
BYTE
ID[2]
"IID_IN_I_20Byte"
ID[3]
"IID_IN_I_20Byte"
ID[4]
"IID_IN_I_20Byte"
ID[5]
"IID_IN_I_20Byte"
ID[6]
"IID_IN_I_20Byte"
ID[7]
"IID_IN_I_20Byte"
ID[8]
"IID_IN_I_20Byte"
ID[9]
"IID_IN_I_20Byte"
ID[10]
"IID_IN_I_20Byte"
ID[11]
"IID_IN_I_20Byte"
Note
Number of IDs transferred
"number_MDS" specifies the number of IDs (1 to 11; handle IDs and EPC IDs) transferred
with the "INVENTORY" block. To receive the IDs of all transponders located in the antenna
field, it may be necessary to run the "
INVENTORY" block again with ATTRIBUTE "0x82".
You will find more detailed information on the individual status modes in the manuals
matching the modes "FB 45", "FB55" and "SIMATIC RF620R/RF630R".
The identifiers of the status modes correspond to the following identifiers in the other
manuals:
0x82
≙
0x02
0x83
≙
0x03
0x85
≙
0x05
0x90
≙
0x10
0x91
≙
0x11
0x92
≙
0x12