Siemens SIMATIC Ident - Page 37

Setting parameters for blocks
3.4 Programming Ident blocks
Ident profile and Ident blocks, standard function for Ident systems
Function Manual, 10/2018, C79000-G8976-C387-04
37
Name
Type
Comment
UID[20]
"IID_IN_I_8BYTE"
UID[21]
"IID_IN_I_8BYTE"
UID[22]
"IID_IN_I_8BYTE"
UID[23]
"IID_IN_I_8BYTE"
UID[24]
"IID_IN_I_8BYTE"
UID[25]
"IID_IN_I_8BYTE"
UID[26]
"IID_IN_I_8BYTE"
UID[27]
"IID_IN_I_8BYTE"
UID[28]
"IID_IN_I_8BYTE"
UID[29]
"IID_IN_I_8BYTE"
reserved1
DWORD
Data
ARRAY[1..222] of
BYTE
Note
Number of handle IDs
"number_MDS" specifies the number of handle IDs (1 to 29) transferred with the
"INVENTORY" block. To receive the hand
le IDs of all transponders located in the antenna
field, it may be necessary to run the "INVENTORY" block again with ATTRIBUTE "0x82".
Table 3- 15 ATTRIBUTE "0x85" (data type "IID_INVENT_85_RF600")
Name
Type
Comment
reserved
BYTE
number MDS
STRUCT
Number of MDS
ID
BYTE
ID[1]
BYTE
Handle
ARRAY[1..8] of BYTE
Handle[1]
BYTE
Handle[2]
BYTE
Handle[3]
BYTE
Handle[4]
BYTE
Handle[5]
BYTE
Handle[6]
BYTE
Handle[7]
BYTE
Handle[8]
BYTE
EPC
ARRAY[1..12] of
BYTE
EPC[1]
BYTE
EPC[2]
BYTE
EPC[3]
BYTE
EPC[4]
BYTE