EasyManuals Logo

Siemens SIMATIC IPC277E User Manual

Siemens SIMATIC IPC277E
158 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #135 background imageLoading...
Page #135 background image
Technical specifications
8.6 BIOS description
SIMATIC IPC277E
Operating Instructions, 11/2019, A5E35783335-AE
135
8.6.7 Alarm, error and system messages
During startup (the boot process), the BIOS first performs a Power On Self Test (POST) and
checks whether certain functional units of the PC are operating error-free. The boot
sequence is immediately interrupted if critical errors occur.
BIOS initializes and tests further functional units if the POST does not return any errors. In
this startup phase, the graphics controller is initialized and any error messages are output to
the screen.
The error messages output by system BIOS are listed below. For information on error
messages output by the operating system or application programs, refer to the
corresponding manuals.
On-screen error messages
On-screen error message
Meaning / tip
Operating system not found Possible causes:
No operating system installed
Incorrect active boot partition
Wrong boot drive settings in SETUP
Keyboard controller error Controller error.
Contact your technical support team.
SMART failure detected on HDD Hard disk reports pending failure through
S.M.A.R.T.
CMOS battery failed
CMOS battery is not connected.
CMOS battery weak
CMOS battery is weak
Real-time clock has lost power The CMOS clock was operated without battery or
with a battery that was too weak, during battery
change, for example. Check the CMOS clock.
Keyboard error
Field PG: Internal keyboard defective and no
external keyboard connected
Other devices: Keyboard defective or not
connected
PLD configuration failed Programming of the PLC on the motherboard
has failed.

Table of Contents

Other manuals for Siemens SIMATIC IPC277E

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMATIC IPC277E and is the answer not in the manual?

Siemens SIMATIC IPC277E Specifications

General IconGeneral
BrandSiemens
ModelSIMATIC IPC277E
CategoryIndustrial PC
LanguageEnglish

Related product manuals