Siemens SIMATIC IPC327G - Page 61

Technical specifications
7.4 Technical data
SIMATIC IPC327G
Operating Instructions, 09/2021, A5E51366275-AA
61
M.2 Module
• Slot X100: support NGFF M.2
2230/2242/2260/2280/3030/3042/3052 with Key B/Key B+M
• Slot X101: support NGFF M.2
2230/2242/2260/3030/3042 with Key B/Key B+M
Max. permitted totally power loss
for each M.2 B key module
2.5 W
Drive, memory medium
M.2 NVMe/SATA SSD
• Slot X103: support NGFF M.2 2230/2242/2280 with Key
M/Key B+M
• Without drive
• 256 GB EcoSSD
• 512GB Eco SSD
USB stick
External, can be connected via USB port
Graphics
Graphics controller
Intel® Integrated UHD Graphic Controller
Resolution, graphics memory
• 2 × DP++, support resolution up to 4096 × 2160 pixel at 60Hz
Interfaces
Ethernet 2 × Gigabit Ethernet interface (two RJ45) electrically isolated,
Wake on LAN and Remote Boot are supported:
• X1P1: Marwell 88E1512
• X2P1: Marwell 88E1512
COM1/2/3/4
• COM1/2: RS232/RS422/RS485
1
(switchable), D-sub connector, 9-pin
• COM3/4: RS232 (optional), max. 115 Kbps, D-sub connector, 9-pin
USB
On the interface panel:
• 4 × USB 3.1 (900mA)
You can find additional information in the section "Power demand of the
components (Page 63)".
DP
Connection of a DP monitor
Keyboard, mouse
Connection via USB port
Audio (optional)
Connection for analog audio source and speaker
1
In BIOS Setup, you can configure support for RS232/RS422/RS485 for COM1 and COM2 ports.