Configuring with Web Based Management
5.6 "Interfaces" menu
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
196 Configuration Manual, 11/2014, C79000-G8976-C350-03
The CSV file contains information on the configuration of the device and detailed information
on all individual measurements and is divided into two areas: The first area contains the
configured settings:
● The system name of the client
● The IP address of the device
● The MAC address of the device
● The total number of measured values
● The interval between acquisition of two measured values
● The maximum data rate
● The setting of the external antennas
● The maximum possible transmit power
The second area is a table. The table contains the following for each measured value:
● The consecutive number of the measurement
● The time stamp
● The BSSID
● The received signal strength in % and in dBm
● The raw value of the RSSI (Received Signal Strength Indication)
● The roaming indicator. The indicator changes between 0 and 1 with each roam
● The channel on which the client is connected to the access point
● The average data rate (if there is no data exchange between the access point and client,
the data rate is "0")
● The name of the access point
● The current channel (this can also be the channel that the client is currently scanning)
To Next Page
Loading...
Need help?
General
