Configuring with Web Based Management
5.6 "Interfaces" menu
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
Configuration Manual, 11/2014, C79000-G8976-C350-03
175
●
Specify the number of hardware retries. The hardware repetition is performed by the
WLAN chip itself when it tries to repeat an unacknowledged packet immediately.
If all hardware repetitions were unsuccessful, the packet is deleted.
●
Force roaming on link down (Only in access point mode)
If the wired Ethernet interface is no longer available (cable break, connector removed), a
client connected over the wireless network is not aware of this. The access point can
force the logged-on clients to roam by deactivating its WLAN interface. The client then
attempts to log on at a different access point. You enable this feature by selecting the
"Force Roaming on link down" check box.
1. Enter the values to be set in the input boxes as follows.
2. Click the "Set Values" button.
Overview of IWLAN antennas:
To Next Page
Loading...
Need help?
General
