Configuring with Web Based Management
5.3 "Wizard" menu
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
Configuration Manual, 11/2014, C79000-G8976-C350-03
57
●
Enter a WPA(2) key. The key can be 8 to 63 ASCII characters or exactly 64 hexadecimal
characters long. This WPA(2) key must be known on both the client and the access point
and is entered by the user at both ends.
Note
The WPA(2) key can be 8 to 63 ASCII characters or exactly 64 hexadecimal characters
long. It should be selected so that is complex for example consisting of random numbers,
letters (upper
-/lowercas
e), have few repetitions and special characters. Do not use known
names, words or terms that could be guessed. If a device is lost or if the key becomes
known, change the key on all devices to maintain security.
●
WPA(2) Pass Phrase Confirmation
Confirm the entered WPA(2) key.
Dot1x Supplicant Settings
Introduction
On this Basic Wizard page, you configure the user name and the password with which the
client will be logged on with the RADIUS server.
If you require additional authentication methods, you can configure them after completing the
Basic Wizard with "Security > WLAN > Client Radius Supplicant".
Note
This page is only available in client mode.
To Next Page
Loading...
Need help?
General
