Siemens SIMATIC NET SCALANCE W721-1 User Manual

Configuring with Web Based Management
5.9 "Security" menu
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
Configuration Manual, 11/2014, C79000-G8976-C350-03
231
●
HTTPS
Specify whether the station (or the IP address) accesses the device using the HTTPS
protocol.
●
SSH
Specify whether the station (or the IP address) accesses the device using the SSH
protocol.
●
Px
Specify whether the station (or the IP address) accesses the device via this port.
●
WLAN 1
(client mode only)
Specify whether or not the station or the IP address accesses the device via the WLAN
interface.
●
VAP X.Y
(access point mode only)
Specify whether or not the station or the IP address accesses the device via the VAP
interface.
●
WDS X.Y
(access point mode only)
Specify whether or not the station or the IP address accesses the device via the WDS
interface.
Procedure
Changing the entry
1. Configure the data of the entry you want to modify.
2. Click the "Set Values" button to transfer the changes to the device.
Creating new entry
1. In the "IP Address" input box, enter the IP address of the device and in the "Subnet
Mask" input box the corresponding subnet mask.
2. Click the "Create" button to create a new row in the table.
3. Configure the entries of the new row.
4. Click the "Set Values" button to transfer the new entry to the device.
Deleting entries
1. Select the check box in the row to be deleted.
2. Repeat this procedure for every entry you want to delete.
3. Click the "Delete" button. The entries are deleted and the page is updated.
Note
Note that a bad configuration may mean that you can no longer access the device.
You can then
only remedy this by resetting the device to the factory defaults and then
reconfiguring.

Siemens SIMATIC NET SCALANCE W721-1 Specifications

General

Brand	Siemens
Model	SIMATIC NET SCALANCE W721-1
Category	Control Unit
Language	English