Appendix D
D.1 Messages in the event log
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
250 Configuration Manual, 11/2014, C79000-G8976-C350-03
You enable or disable the "Spanning Tree" event in "System > Events"
Spanning Tree: topology change detected. The topology of the network has changed; the network will be reor-
Spanning Tree: new root bridge xx:xx:xx:xx:xx:xx
detected.
The topology of the network has changed; there is a new root bridge
with MAC address xx:xx:xx:xx:xx:xx in the network.
RADIUS: Access accepted / rejected for client
The authentication of the client was successful or not successful.
Messages about message system
Syslog-Server not reachable!
The configured Syslog server is not accessible.
Unable to send messages to syslog server.
Please check syslog socket configuration.
The syslog server configuration is incomplete.
Unable to send e-mail(s) because of IP connec-
Sending of e-mail(s) failed. SMTP server cannot be reached (e.g. net-
work connection interrupted).
Unable to send e-mail(s) because of SMTP au-
Sending of e-mail(s) failed. Authentication of the client on the SMTP
Unable to send e-mail(s) because SMTP mes-
sage transfer failed.
Sending of e-mail(s) failed. SMTP server can be reached, configuration
incomplete or contains errors (e.g. receiver e-mail address wrong /
SNMP: Authentification failure. Authentication of an SNMP client failed; access not possible (e.g.
SNMPv1/v2 read-only configured o
r Read Community String incorrectly
configured).
IP communication is possible. Remote logging
IP communication is possible. Remote logging is activated.
IP communication is not possible. Remote log-
ging deactivated. Please check IP configuration
and network connectivity.
IP communication is not possible. Remote logging is deactivated.
Check whether or not the device has an IP address.
To Next Page
Loading...
Need help?
General
