Configuring with Web Based Management
5.3 "Wizard" menu
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
Configuration Manual, 11/2014, C79000-G8976-C350-03
43
The Basic Wizard page contains the following boxes:
●
"Restore Memory Defaults and Restart" button
If you click this button, the factory configuration settings are restored with the exception of
the parameters below followed by a restart.
– IP address
– Subnet mask
– IP address of the default gateway
– DHCP client ID
– DHCP
– System name
– System location
– System contact
– User names and passwords
– Mode of the device
After restarting the device, you will need to log on again and start the Basic wizard again to
configure the device.
●
"Device Mode" drop-down list
Select the mode of the device. This selection is available only for access points.
The following operating modes are possible:
– AP: Access point mode
– Client: Client mode
To Next Page
Loading...
Need help?
General
