Configuring with Web Based Management
6.5 "System" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13
197
Private MSPS MIB file "Scalance_w_msps.mib"
RunningCLI Text file with CLI commands
This file contains an overview of the current config-
uration in the form of CLI commands. Passwords
are masked in this file as follows: [PASSWORD]
You can download the text file. The file is not in-
tended to be uploaded again unchanged.
-- X --
Text file with CLI commands
StartupInfo Startup log file
This file contains the messages that were entered
in the log file during the last startup.
-- X --
File with user names and passwords
WBMFav WBM favorites
This file contains the favorites that you created in
the WBM. You can download this file and upload it
X X X
WLANAuthlo
g
File with entries from the WLAN Authentication Log
(information on successful or failed authentication
-- X --
WLANCert
(in client
mode only)
User certificate. You can specify a password for the
user certificate on the WBM page "Load&Save >
Password".
Maximum file size: 8192 bits
X X X
WLANServC
ert
(in client
mode only)
Server certificate
Maximum file size: 8192 bits
X X X
WLANSigRe
c
(in client
mode only)
The zip file contains the following:
• csv file with the measured values of the signal
recorder
• pdf file with the measured values and an addi-
tional graphic representation of the measured
values.
You will find information about the measured val-
ues and their graphic representation in the section
"Signal recorder (Page 305)".
-- X X
WLANSpec-
trumAnalyz-
er
(Only in
access point
The Zip file contains a csv file with the measured
values of the spectrum analyzer.
You will find information about the measured val-
ues and their graphic representation in the section
"Spectrum analyzer (Page 316)".
-- X X
To Next Page
Loading...
Need help?
General
