Siemens SIMATIC NET SCALANCE W780 Series User Manual

Configuring with Web Based Management
6.5 "System" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
250 Configuration Manual, 08/2018, C79000-G8976-C267-13
6.5.15
Syslog Client
System event agent
Syslog according to RFC 3164 is used for transferring short, unencrypted text messages
over UDP in the IP network. This requires a Syslog server.
Requirements for sending log entries:
● The Syslog function is enabled on the device.
● The Syslog function is enabled for the relevant event.
● There is a Syslog server in your network that receives the log entries. (Since this is a
UDP connection, there is no acknowledgment to the sender)
● The IP address or the FQDN (Fully Qualified Domain Name) of the Syslog server is
entered in the device.
Description
The page contains the following boxes:
●
Syslog Client
Enable or disable the Syslog function.
●
Syslog Server Address
Enter the IP address, the FQDN (Fully Qualified Domain Name) or the host name of the
Syslog server.
This table contains the following columns
●
Select
Select the row you want to delete.
●
Syslog Server Address
Shows the IP address, the FQDN (Fully Qualified Domain Name) or the host name of the
Syslog server.
●
Server Port
Enter the port of the Syslog server being used.

Siemens SIMATIC NET SCALANCE W780 Series Specifications

General

Brand	Siemens
Model	SIMATIC NET SCALANCE W780 Series
Category	Wireless Access Point
Language	English