Siemens SIMATIC NET SCALANCE W780 Series User Manual

Troubleshooting/FAQ
8.3 Compatibility with predecessor products
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
434 Configuration Manual, 08/2018, C79000-G8976-C267-13
8.3
Compatibility with predecessor products
Mixed mode
Mixed operation with predecessor products (6GK57xx-xAA60-xAx0) is possible.
Further information about predecessor products can be found on the Internet at Siemens
Industry Automation and Drives Service & Support, entry ID: 42784493
(https://support.industry.siemens.com/cs/ww/en/view/42784493)
Note the following points if you want to make mixed operation possible:
● Transmission standard IEEE 802.11a/b/g/n
The transmission standards IEEE 802.11a/b/g/n are compatible with the predecessor
products. The setting "802.11n only" is not compatible with the predecessor products.
The transmission standards IEEE 802.11a/g/h Turbo of the predecessor products are not
supported.
● Security settings
The transmission standards IEEE 802.11a/b/g support the same security settings as the
predecessor products.
The transmission standard IEEE 802.11n with the setting "802.11n" or "802.11n only"
only supports WPA2/ WPA2-PSK with AES in the security settings.
● SSID
For SSID, use only the characters that were supported by the previous products.
● Management only over wired Ethernet interface
In the previous products, there was a function "Management only over wired Ethernet
interface". In the new devices this function is covered by the "Management ACL" function.
● iPCF / iPCF-MC
The IEEE 802.11b transmission method is not supported together with iPCF.
The SCALANCE W700-xRR devices must not be configured with the operating mode
IEEE 802.11b in mixed operation.
● WDS ID
With WDS ID, do not use the ASCII character 0x22 ( " ).
● Key for WEP or AES
With devices with firmware up to version 3.2, the keys for WEP or AES may only contain
ASCII characters or hexadecimal characters from 0x20 to 0x7E.
● Key for WPA(2)-PSK
For devices with firmware version ≤ 5.0, the keys for WPA(2)-PKS can only consist of
ASCII characters or hexadecimal characters from 0x20 to 0x7E.
For devices with firmware version ≥ 5.1, the following specifications apply to WPA(2)-PKS
keys:
– For a key with 8 to 63 characters, you can only use the following readable ASCII
characters: 0x20 - 0x7e.
– For a key with precisely 64 characters, you can use the following ASCII characters: 0 -
9, a - f and A - F.

Siemens SIMATIC NET SCALANCE W780 Series Specifications

General

Brand	Siemens
Model	SIMATIC NET SCALANCE W780 Series
Category	Wireless Access Point
Language	English