Configuring with Web Based Management
6.5 "System" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
230 Configuration Manual, 08/2018, C79000-G8976-C267-13
The table has the following columns:
●
Select the row you want to delete.
●
Shows the defined group names.
●
Shows the configured security level.
●
Enable or disable read access for the required group.
●
Enable or disable write access for the required group.
Note
For write access to work, you also need to enable read access.
●
Shows whether or not the group is assigned to an SNMPv3 user. If the group is not
assigned to an SNMPv3 user, no automatic saving is triggered and the configured group
is deleted after restarting the device.
– Yes
The group is assigned to an SNMPv3 user.
– No
The group is not assigned to an SNMPv3 user.
Procedure
Creating a new group
1. Enter the required group name in "Group Name".
2. Select the required security level from the "Security Level" drop-down list.
3. Click the "Create" button to create a new entry.
4. Specify the required read rights for the group in "Read".
5. Specify the required write rights for the group in "Write".
6. Click the "Set Values" button.
To Next Page
Need help?
General
